Rubber Boots and Gaiters

This rubber Boot fits onto the cable and over the Dynamo terminal to protect and insulate itto fit:Classic Fiat 500 all models (up to 1973)Fiat 126 594cc early models with Dynamo (up to 1976)Dimmensions:Total Length: 45mmWidth: 20mmDepth: 230mmInternal Diame..

Rubber Head Lamp Bulb Cover to insulate and keep the damp out of the Head LampFits at the rear of the Head Lamp and the Bulb connector fits through itto fit:Classic Fiat 500 all modelsFiat 126 all models Fiat 600 all modelsFiat 850 all models..

This Boot fits onto the drive shaft on the inside (engine/gearbox side)It has an built in Oil Seal and incapsulated plastic bush to fit onto the drive shaftDiameter at Base: 27mmto fit:Fiat 850 & 850T all models..

Brand NewMade in ItalyThis is a Rubber Boot to insulate the connection on the Oil Pressure Switchto fit:Classic Fiat 500 all modelsFiat 126 all modelsFiat 600 all modelsFiat 850 all modelsIf you have any questions please contact us for help..

Made in ItalyThis Boot fits on the outside of the Drive Shaft where it connects to the WheelIt is basically a rubber dust cover and fits onto the Drive Shaft and around the lip of the FlangeDiameter:  22-24mm (larger type shaft)(These are designed to be nice tight fit so they ma..

This rubber Boot fits onto the cable and over the battery terminal to insulate itFits most Battery TypesFor the POSITIVE + Terminal Dimmensions:Length: 57mmWidth: 40mmDepth: 20mmInternal Diameter of Wire Cover: 15mmLength of Wire Cover: 35mm ..

Made in ItalyThis is a rubber dust cover that fits onto the outside of the clutch fork (see diagram)to fit:Fiat 850 Sports Coupe..

The benefit of these tie straps over plastic ones is that they are made from non corrosive stainless steel They are mainly designed to be fitted to CV Boots which are under constant threat from water, heat and road grime..

This rubber Boot fits onto the cable and over the Starter Motor terminal or any electrical terminal to protect and insulate itIf you need any help please contact us..

This rubber Boot fits onto the cable and over the Starter Motor terminal or any electrical terminal to protect and insulate itIf you need any help please contact us..

This Boot simply pushes on and replaces the split boot on the steering ball jointsto fit:Classic Fiat 500 all models (up to 1974)Fiat 600 all modelsFiat 850 all modelsFiat 124 all modelsFiat 126 all models (up to 1999)Fiat 127 & 128If you have any quer..