Rubber Gaskets, Seals & Grommets

To fit over the Accelerator/Throttle Pedal to add gripto fit:Classic Fiat 500 all models (up to 1974)Fiat 126 all  modelsFiat 600 all modelsIf you have any queries or questions please feel free to ask..

This is to fit around the battery support trayto fit hole size 24mmto fit:Fiat 500 all models..

Quality Rubber Made in ItalyThis rubber pad or grommet fits around the Bonnet and rear Engine Lid aperture to fit:Classic Fiat 500 all models..

This kit fits around the aperture of the front Bonnet Seal to make the opening and closingsmoother and keep the gaps consistentto fit:Classic Fiat 500 all modelsIf you have any questions or queries please feel free to ask..

This rubber cone shaped grommet fits onto the front panel and the bonnet closes down onto itIt is also used on the sunroof to stop the handle Length of Cone: 19mmDiameter of base: 19mm  to fit:Classic Fiat 500 all modelsFiat 126, Fiat 600, 1100 all ..

Genuine Fiat PartsTo fit over the Brake and Clutch Pedal to add gripto fit:Classic Fiat 500 all models (up to 1974)Fiat 126 all  modelsFiat 850 Special & various modelsIf you have any queries or questions please feel free to ask..

Rubber Seal/Gasket to fit between the Bumper Bracket and the bodyworkand prevent any marks or damageto fit:Classic Fiat 500 all modelsFiat 126Fiat 600If you have any queries or questions please feel free to ask..

This is a set of FOUR Rubber Seal/Gasket to fit between the Bumper Bracket and the bodyworkand prevent any marks or damageto fit:Classic Fiat 500 all modelsFiat 126Fiat 600If you have any queries or questions please feel free to ask..

Made in ItalyThis is a Black Plastic Plug that fits into the hole where the check strap bolt fits intoto fit:Classic Fiat 500 F/L/R all modelsIf you have any questions please contact us for help..

This is a rubber seal that is located where the Door Hinges are to protect the interior light switch from waterThis is for ONE Sealto fit:Classic Fiat 500 all models (up to 1974)If you have any questions please feel free to ask..

Rubber Strap with reinforced holes at either end that connects to the Door to stop it flying backThere is one fitted per doorPrice is for ONE Strapto fit:Classic Fiat 500 N/D/G (suicide door) all modelsIf you have any questions please contact us for help..

This rubber pad or grommet fits around the Door aperture on the top and bottomThere are TWO per Doorto fit:Classic Fiat 500 all models..

This is for ONE (1) metre of Rubber Channel thats fitted around the door opening glassThis is usually fitted inside the aperture of the door around the door glass, and stays in place due to the flexible spine that into the gapSize 14.5mm x 13mmto fit:Classic Fiat 500 all models ..

This is a 20 metre Roll Rubber & Metal ChannelAs you can see from the additional photos it should fit along the top edge of the door and down the back, and the door glass will move up and down inside it13mmx14.5mmto fit:Classic Fiat 500 all models (up to 1974)Fiat 126 a..

This Rubber & Metal Channel is measured for ONE Door to fit along the top and down the rear of the door glass and into the doorAs you can see from the additional photos it should fit along the top edge of the door and down the back, and the door glass will move up and down inside itFiat..

These Grommets fit either side of the aperture of the rear Engine Lid to make the opening and closingsmoother and keep the gaps consistentto fit:Classic Fiat 500 all models (NOT Giardiniera)If you have any questions or queries please feel free to ask..

Made in ItalyThis is a Rubber Plug to fill the holes on the floor either side of the tunnelThere are usually 6 holes (3 per side)to fill hole 20mm Diameterto fit:Classic Fiat 500 all modelsIf you have any questions please contact us for help..

This Rubber Channel is measured for ONE DoorThis Channel fits where the door glass meets the Quarter Light Frame upright (see diagram in related photos)Narrow TypeFiat Part No: 4070123 (as per diagram in related photos)to fit:Classic Fiat 500 all models up to 1972..

Rubber Seal to fit the Front Indicator Lamp, between the Lens and Bulb Holder to fit:Classic Fiat 500 D all models If you have any questions please contact us for help..