Fiat/Seat 600 Parts

Original Quality Partsmade by SKFThis Kit consists of:1 x Outer Wheel Bearing1 x Inner Wheel Bearing1 x Spacer2 x Oil Seal1 x Split Pin1 x Rear Hub Nutto fit:Classic Fiat 500 D/F/L/RFiat 126 all modelsFiat 600 all modelsFiat 850 ..

Fits at the rear of the car on each wheel and operates the Brake ShoesWith Quality Pirelli Rubber Seals  to fit:Fiat 600D/E all models(NOT SUITABLE FOR EARLY FIAT 600 WITH ALUMINIUM BRAKE SHOES) If you are in any way unsure please contact our offic..

Rear Wheel CylinderDiameter: 19.05mmto fit:Fiat 600 D  with Aluminium Brake Shoes  (from 1955 to 61)Fiat 600 Multipla  with Aluminium Brake Shoes  (from 1955 to 61)Fiat 850 Familiare  with Aluminium Brake Shoes  (from 1955 to 61)If you have any questions please..

Fully Factory re-built Dynamo with all new parts fittedFully Guaranteed and supplied with a 12 month warrantyto fit:Fiat 600 all modelsIMPORTANT: As these are reconditioned units we would need your old one back in exchange. Unless you plan to send us your old unit..

Reconditioned by professionals complete with 1 Year Limited WarrantyThis Engine has been fully reconditioned with new parts where availableThe Engine has been stripped down and the old parts replaced with new Bearings, Pistons, Rings, Rods and Gaskets etc etcIt comes complete w..

Fully Factory re-built Starter Motor with all new parts fittedFully Guaranteed and supplied with a 12 month warrantyto fit:Classic Fiat 500 N/D all modelsFiat 600 series 1 (with cable pull start)This Starter Motor Has a 2 Bolt Flange to fitIMPORTANT:  As these are..

Fully ReconditionedThis is a Steering Box complete with the Arm for a Right Hand Drive vehicleto fit:Fiat 600 all modelsIf you have any questions please contact us for helpPLEASE NOTETHIS IS A RECONDITIONED ITEM AS NEW ONES ARE NO LONGER AVAILABLE. IN RETURN..

These Stub Axles are fully factory reconditioned in Italy using Brass Bushes to last much longerThey have new top Bushes, Pins, Washers and Bushes and are ready to fit.The Kit also comes with two new Hub Nuts(Once fitted they must be greased fully using a grease gun until the g..

This is a metal stud that's used to repair a worn thread instead of a helicoil with these dimmensionsTotal Length 45mmLong Thread Length 14mm (M9)Short Thread Length 12mm (M8)to fit:Fiat Various modelsLancia Various modelsAlfa Romeo Various modelsAutob..

This is a metal stud that's used to repair a worn thread with these dimmensionsTotal Length 54mmShort Thread 15mm M9Long Thread 18mm M8Shoulder 21mmto fit:Fiat Various models Lancia Various modelsAlfa Romeo Various modelsAutobianchi Various modelsIf you have any questions please contact us for help..

This is a metal stud that's used to repair a worn thread with these dimmensions Total Length 40mmShort Thread 11mm M10Long Thread 20mm M8to fit:Fiat Various models Lancia Various modelsAlfa Romeo Various modelsAutobianchi Various modelsIf you have any questions please contact us for help..

This part fits to the Distributor shaft and once connected to the correct Cable (sold separately) will give an accurate Rev counter readingto fit:Classic Fiat 500 all modelsFiat 600 all modelsIf you have any questions please contact us for help ..

Fiat Part No: 4145587to fit:Fiat 600 all modelsFiat 600 Multipla all modelsFiat 850 all modelsFiat 900 all modelsClassic Fiat Panda  903cc & 965ccFiat Uno 903ccFiat 127 903ccAutobianchi A112If you have any questions please contact us for help..

Grey Cloth Lined Roof Lining as originalThis hard but flexible Lining fits on the inside of the roofto stop any resonance and also avoid condensationMade to original specificationto fit:Fiat 600 all modelsIf you have any questions please contact us for help..

Good Quality PartMade by FACET in Italyto fit:Classic Fiat 500 N/D/F/L 499cc (up to 1972)Fiat 600 all modelsIf you have any questions please feel free to ask..

This is a Rubber Gasket that seals the ashtray onto the dashboard to fit:Classic Fiat 500Fiat 126Fiat 600plus other Fiat models  ..

This Rubber Blanking Plug is used to block a holeDimmensions:  to fit in hole 35mm wideto fit:Classic Fiat 500 all modelsClassic Fiat many modelsIf you have any questions please contact us for help..

Brand NewMade in Italyto fit:Fiat 600 all modelsIf you have any questions please contact us for help..

This Rubber Buffer Strip fits onto the top of the Front Panel and the Bonnet stuts down on top of it to fit:classic Fiat 500 all models N/D/F/L/R/G all models If you have any questions please feel free to ask..

This is for 1 METRE of Rubber Finisher Seal with metal spine for a secure fitto fit around the aperture of the top doors and dashboardto fit:Classic Fiat 500 Gamine all models..