Reconditioned Parts

This is fully reconditionedBlasted & Powder CoatedFinished as original and ready to installNot including Air Filter LidThis has the small size air filter casing(not the same as the later 500 F/L/R models)to fit:Classic Fiat 500 N/D models (pre 1966)Autobian..

This is fully reconditionedBlasted & Powder CoatedFinished as original and ready to installNot including Air Filter Lid (sold separately RIC-1938)This has the standard size air filter casing(not the same as the early pre-1966 smaller air filter)to fit:Classic F..

Quality PartsMade in PolandFor POLISH ZELMOT Alternator ONLYto fit:Classic Fiat 500 all models (with POLISH ZELMOT ALTERNATOR FITTED)Fiat 126 air cooled (with POLISH ZELMOT ALTERNATOR FITTED)If you have any questions please contact us for help..

Quality PartsMade in ItalyFor MAGNETTI MARELLI Alternator ONLY with EXTERNAL BRUSH HOLDERto fit:Classic Fiat 500 all models (with MAGNETTI MARELLI ALTERNATOR FITTED)Fiat 126 air cooled (with MAGNETTI MARELLI ALTERNATOR FITTED)If you have any questions please co..

Quality PartsMade in ItalyFor MAGNETTI MARELLI Alternator ONLY with INTERNAL BRUSH HOLDERto fit:Classic Fiat 500 all models (with MAGNETTI MARELLI ALTERNATOR FITTED)Fiat 126 air cooled (with MAGNETTI MARELLI ALTERNATOR FITTED)If you have any questions please co..

This is a semi circle shaped metal key that fits into the shaft of an Alternator, Water Pump and other parts4mm Widthto fit:Classic Fiat 500 all modelsFiat 126 all modelsFiat 850 all modelsIf you have any questions please contact us for help..

This is a Brand New Kit of TWO Stub Axles for the Left & RightThey have new top Bushes, Pins, Washers and Bushes and are ready to install This kit is also modified with bearings top and bottom for a smoother action Supplied with two new Hub Nuts (Once..

This is a kit of TWO (2) Bearings to fit either end of the Dynamoto fit:Classic Fiat 500 N/D/F/L/R all modelsFiat 126 early models with 594cc engineIf you have any questions please contact us for help..

OE Quality PartsMade in ItalyThis is a Dynamo Hub assembled with a Pulley & Shims and ready to installto fit:Classic Fiat 500 N/D/F/L/R all modelsFiat 126 series 1 594cc (up to 1978)..

This three piece kit is for the metal strap that holds the dynamo in place to secure it to the engineto fit:Classic Fiat 500 N,D,F,L,R all models (except Giardiniera)Fiat 126 early models (up to 1977)If you have any questions please contact us for help..

This is a semi circle shaped metal key that fits into the shaft of an Dynamo to lock the Hub3mm Widthto fit:Classic Fiat 500 all models with DynamoFiat 126 (594cc with Dynamo)If you have any questions please contact us for help..

This is a reconditioned part thats powder coated and ready to installSupplied with fittingsto fit:Classic Fiat 500 N/D/F/L/R all modelsFiat 126 air cooled all modelsAutobianchi Bianchina..

Reconditioned Original Front Oil Pump/Timing Chain CoverIncluding Brand New Oil Pump,Oil Seal & GasketFitted at the Front of the Engine (see diagram)to fit:Classic Fiat 500 (650cc)Fiat 126 (Air Cooled ONLY)If you have any questions please contact us for hel..

Brand NewFactory Standard Cast Iron Front Upright for Stub Axles (SAME FOR BOTH SIDES)Ready to install and recondition your old existing Stub AxlesSupplied with a New King Pin Repair Kit (ONE SIDE ONLY)Parts Supplied1x. Stub Axle Upright1x King Pin Repair Kit1x Top ..

Fully Reconditioned Steering Boxfor Left Hand Drive Cars onlyPLEASE NOTE: The Shaft has 17 Splines on the Shaft where it meets the Steering Shaft inside the carto fit:Classic Fiat 500R & 126 all modelsPLEASE NOTE: This is a reconditioned part so we would need your old St..

This is a THREE Piece kit of insulators for the Dynamo (see photo)to fit:Classic Fiat 500 all modelsFiaat 126 early models (up to 1978)..

Fully Factory re-built Alternator with all new parts fittedFully Guaranteed and supplied with a 12 month warranty(This Alternator has a Voltage Regulator built in)to fit:Fiat 126 704cc Bis models (up to 1993)IMPORTANT:  As these are reconditioned units we would nee..

This is a fully rebuilt carburettor including top and bottom gasket ready to installMade by FOS in POLANDModel: 28S1Ato fit:Fiat 126 ELPlease email us with any queries or questions..

This is a Genuine Fiat Crankshaft that's been professionally Vapour Blasted inside and out, Ground,Polished and cleaned and is ready to installwith new OE Quality Italian bearingsThis kit consists of1x  Crankshaft1x  Front Main Bearing1x  Rear Main Bearing1x  Set Bearin..

This is a Crankshaft thats been professionally Ground/Polished and cleaned and is ready to installThis kit consists of 1x  Crankshaft1x  Front Main Bearing1x  Rear Main Bearing1x  Set Bearing Shellsto fit:Fiat 126 BIS all Water Cooled modelsTHIS IS A RECONDITIONED PART SO WE..